P2617 - Crankshaft Position Output Circuit/Open

DTC DESCRIPTION P2617 - CRANKSHAFT POSITION OUTPUT CIRCUIT/OPEN

Description:	This DTC sets when PCM detects that the crankshaft position (CKP) sensor bias voltage is less than the calibrated minimum or greater than the calibrated maximum calculated threshold.
Possible Causes:	CKP+ circuit open CKP+ circuit intermittent open CKP- circuit open CKP- circuit intermittent open CKP+ circuit short to voltage CKP+ circuit intermittent short to voltage CKP- circuit short to voltage CKP- circuit intermittent short to voltage CKP+ circuit short to ground CKP+ circuit intermittent short to ground CKP- circuit short to ground CKP- circuit intermittent short to ground CKP sensor incorrectly installed Damaged CKP sensor
Diagnostic Aids:
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to Pinpoint Test JD.