P2096 - Post Catalyst Fuel Trim System Too Lean (Bank 1)
DTC DESCRIPTION P2096 - POST CATALYST FUEL TRIM SYSTEM TOO LEAN (BANK 1)
| Description: | The PCM monitors the correction value from the heated oxygen sensor bank 1, sensor 2 (HO2S12) as part of the fore-aft oxygen sensor control routine. This DTC sets when the correction value is greater than a calibrated limit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Inspect the connectors for signs of damage, water intrusion or corrosion. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test DZ. | ||