LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Expedition XL, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Memory Modules >> Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid) >> Diagnostic Trouble Code (DTC) Charts And Descriptions >> P112A - Too Many Engine Starts During Factory/Transport Mode

P112A - Too Many Engine Starts During Factory/Transport Mode

DTC DESCRIPTION P112A - TOO MANY ENGINE STARTS DURING FACTORY/TRANSPORT MODE

Description:  This DTC sets when the vehicle is in transport mode and the engine has been started greater than a calibrated number of times. Spark plug fouling may be a concern and the wrench light will flash in one second intervals until the vehicle is taken out of transport mode.
Possible Causes: 
  • Vehicle is in transport mode
  • Excessive engine starts when the vehicle is in transport mode
Diagnostic Aids:   
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test JB.
scientia non olet · About LEMON Manuals