Rear Only Parking Aid Camera

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .

Condition	Possible Causes	Actions
The rear parking aid camera is inoperative	Refer to the Pinpoint Test	GO to Pinpoint Test A
The FDIM or FCDIM displays REAR VIDEO CAMERA IS UNAVAILABLE or CAMERA IS UNAVAILABLE PLEASE CONTACT YOUR DEALERSHIP and a black screen/no image	Refer to the Pinpoint Test	GO to Pinpoint Test A
Static/flashing/blinking/flickering/scrolling or rolling image/screen/scrolling horizontal lines	Refer to the Pinpoint Test	GO to Pinpoint Test B
Poor image quality (foggy/cloudy/fuzzy/blurry/hazy image or moisture/water in lens or black spots)	Refer to the Pinpoint Test	GO to Pinpoint Test B
Camera image quality concern during an auto-start-stop event	Wiring, terminals or connectors Direct Current/Direct Current (DC/DC) converter control module	Refer to: Direct Current/Direct Current (DC/DC) Converter Control Module .
Frozen screen or slow screen transitions	FDIM APIM FCDIM	DIAGNOSE the APIM and FCDIM or FDIM. Refer to: Information and Entertainment System .
Manual zoom function is inoperative	Refer to the Pinpoint Test	GO to Pinpoint Test E
Visual park aid alert is inoperative	Refer to the Pinpoint Test	GO to Pinpoint Test C
Active guidelines are inoperative or do no operate correctly	Refer to the Pinpoint Test	GO to Pinpoint Test D
Fixed guidelines are inoperative or do not operate correctly	Refer to the Pinpoint Test	GO to Pinpoint Test D
The video delay feature is inoperative or does not operate correctly	Refer to the Pinpoint Test	GO to Pinpoint Test F
Video image is upside down	Internal parking aid camera failure Incorrect parking aid camera installed on vehicle	INSTALL a new rear parking aid camera. Refer to: Rear Parking Aid Camera .
All other image concerns	Refer to the Pinpoint Test	GO to Pinpoint Test A