Pinpoint Test BG : The Check Fuel Fill Inlet Message Is Always Displayed
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- BG1 CHECK THE MESSAGE CENTER OPERATION
- Ignition ON.
- Close all doors and the hood.
- Clear all message center warnings by pressing the OK button for each warning present.
- Monitor the door ajar RTT.
- Open the driver door.
- Clear the message center popup warning.
- Monitor the door ajar RTT.
Is the door ajar RTT off with the door closed, and on with the door open?
Yes GO to BG2 No GO to Pinpoint Test A - BG2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: Instrument Panel Cluster (IPC) . No GO to BG3 - BG3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CM DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No DIAGNOSE all PCM Diagnostic Trouble Codes (DTCs). Refer to the appropriate Engine article for the procedure.