Pinpoint Test BO: The Perimeter Alarm Chime Is Inoperative

BO1 CHECK THE SEATBELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the seatbelt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the seatbelt warning chime operate for approximately 6 seconds?

Yes GO to BO2

No GO to Pinpoint Test BQ

BO2 CHECK THE OPERATION OF THE PERIMETER ALARM
- Arm the perimeter alarm using the remote key locking feature (key fob).
- Wait approximately 15 seconds for the system to arm.
- Open the driver door using the interior door handle.
Does the perimeter alarm sound after 12 seconds?

Yes GO to BO3

No Refer to: Perimeter Anti-Theft Alarm .

BO3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

Using a diagnostic scan tool, perform the IPC self-test.

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes	Refer to DTC Chart: IPC in this article. Refer to DTC Chart: Instrument Panel Cluster (IPC) .

No

GO to BO4

BO4 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes Refer to: Body Control Module (BCM) .

No GO to BO5

BO5 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes Refer to: Communications Network .

No INSTALL a new BCM. Refer to: Body Control Module (BCM) .