LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Expedition MAX SSV, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 483 (Cruise Control - Vehicles With: Adaptive Cruise Control) >> Diagnosis And Testing >> Cruise Control >> Pinpoint Tests >> Pinpoint Test K : U0151:00 >> Pinpoint Test K : U0151:00

Pinpoint Test K : U0151:00

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

  1. K1 VERIFY THE CUSTOMER CONCERN

    • Ignition ON.

    • Verify there is an observable symptom present.

    Is an observable symptom present? 

    Yes  GO to  K2
    No  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  2. K2 CHECK THE COMMUNICATION NETWORK

    • Using a diagnostic scan tool, perform the network test.

    Does the RCM pass the network test? 

    Yes  GO to  K3
    No  REFER to Module Communications Network

  3. K3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE CCM (CRUISE CONTROL MODULE) AND THE RCM (RESTRAINTS CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the CCM and RCM self-tests.

    Is DTC U3003:16 or U3003:17 recorded? 

    Yes  If DTC U3003:16 is recorded in the CCM, GO to Pinpoint Test Q  If DTC U3003:17 is recorded in the CCM, GO to Pinpoint Test R  If Diagnostic Trouble Codes (DTCs) are recorded in the F-150, RCM, REFER to AIRBAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
    No  GO to  K4

  4. K4 RECHECK THE CCM (CRUISE CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)

    NOTE: If new modules were installed prior to the DTC being set, the module configuration can be incorrectly set during the PMI or the PMI may not have been performed.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs). Repeat the CCM self-test.

    Is DTC U0151:00 still present? 

    Yes  GO to  K5
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  5. K5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0151:00

    • Clear all Diagnostic Trouble Codes (DTCs).

    • Ignition OFF.

    • Ignition ON.

    • Wait 10 seconds.

    • Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.

    Is DTC U0151:00 set in other modules? 

    Yes  INSTALL a new RCM. REFER to: Restraints Control Module (RCM) .
    No  INSTALL a new CCM. REFER to:Cruise Control Module (CCM) 
scientia non olet · About LEMON Manuals