Pinpoint Test N: The Abs (Anti-Lock Brake System) Warning Indicator Or RTT (RECONFIGURABLE Telltale) Warning Indicator Is Never Or Always On
- Normal Operation and Fault Conditions
See ABS Warning and ABS/Brake/Stability-Traction Control System Indication. REFER to: Instrument Panel Cluster (IPC) - System Operation and Component Description .
If the ABS warning indicator request message is missing for less than 5 seconds, the IPC defaults the ABS warning indicator or RTT warning indicator to its last indication state (on or off), based upon the last message received.
If the ABS warning indicator request message is missing for 5 seconds or longer, the IPC defaults the ABS warning indicator or RTT warning indicator on.
Possible Sources
- Communication concern
- ABS
- GWM
- IPC
- N1 IDENTIFY THE IPC (INSTRUMENT PANEL CLUSTER) LEVEL
- Determine if the vehicle is equipped with a base or mid-level IPC. REFER to: Instrument Panel Cluster (IPC) - Overview
Is the vehicle equipped with a base or mid-level IPC?
Yes GO to N3 No GO to N2 - N2 CHECK THE MESSAGE CENTER OPERATION
- Ignition ON.
- Close all doors, liftgate and the hood.
- Clear all message center warnings by pressing the OK button for each warning present.
- Monitor the door ajar RTT warning indicator.
- Open the driver door.
- Clear the message center popup warning.
- Monitor the door ajar RTT warning indicator.
Is the door ajar RTT warning indicator off with the door closed, and on with the door open?
Yes GO to N4 No GO to Pinpoint Test A - N3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) INDICATOR LAMP CONTROL ACTIVE COMMAND
- Using a diagnostic scan tool, view the IPC Parameter Identifications (PIDs).
- Access the IPC and control the ABS_LAMPPID
- Command the ABS warning indicator on then off.
Does the ABS warning indicator turn on when commanded on and turn off when commanded off?
Yes GO to N4 No GO to N6 - N4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the IPC DTC Chart. No GO to N5 - N5 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network No If the ABS warning indicator is never on, the system is operating correctly. If the ABS warning indicator is always on, DIAGNOSE the ABS module Diagnostic Trouble Codes (DTCs). REFER to:Anti-Lock Brake System (ABS) And Stability Control - N6 CHECK FOR CORRECT IPC (INSTRUMENT PANEL CLUSTER) OPERATION
- Ignition OFF.
- Disconnect and inspect the IPC connector.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the IPC connector. Make sure it seats and latches correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.