LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test DW: U0533:56 Or U0534:56

Pinpoint Test DW: U0533:56 Or U0534:56

  1. DTC Fault Trigger Conditions 
    DTC Description Fault Trigger Condition
    IPC U0533:56 Invalid Data Received From Side Obstacle Detection Control Module "A": Invalid/Incompatible Configuration Sets in the IPC when the IPC receives invalid network data from the SODL through the GWM due to a calibration concern.
    IPC U0534:56 Invalid Data Received From Side Obstacle Detection Control Module "B": Invalid/Incompatible Configuration Sets in the IPC when the IPC receives invalid network data from the SODR through the GWM due to a calibration concern.

    Possible Sources 

    • IPC

  2. DW1 CHECK VEHICLE HISTORY FOR RECENT SERVICE ACTIONS

    • Check the vehicle history for any recent service actions related to the IPC.

    Have any service actions been performed? 

    Yes  REPEAT the PMI as directed by the diagnostic scan tool.
    No  GO to  DW2

  3. DW2 RECONFIGURE THE MODULE

    • Using a diagnostic scan tool, perform the PMI as directed by the diagnostic scan tool.

    • Check the message center for side obstacle and cross traffic alert feature menus.

    Are the feature menus available and working correctly? 

    Yes  The system is operating correctly at this time. The concern may have been caused by incomplete or incorrect PMI procedure.
    No  The IPC fails to retain configuration data. INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) 
scientia non olet · About LEMON Manuals