LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Aid - Vehicles With: 180 Degree Camera/360 Degree Camera/Parking Aid Camera >> Diagnosis And Testing >> Parking Aid >> Pinpoint Test(s) >> Pinpoint Test E: The Manual Zoom Is Inoperative

Pinpoint Test E: The Manual Zoom Is Inoperative

  1. Normal Operation and Fault Conditions 

    REFER to: Parking Aid - System Operation and Component Description .

    Possible Sources 

    • Communication network concern
    • Video camera not configured after replacement
    • Rear parking aid camera
    • APIM concern

    Visual Inspection and Pre-checks 

    • If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Verify the rear video camera configuration using the diagnostic scan tool.

  2. E1 PERFORM A NETWORK TEST

    • Ignition ON.

    • Using a diagnostic scan tool, perform a network test.

    Do all modules pass the network test? 

    Yes  GO to  E2
    No  See the Symptom Chart: Communication Network. REFER to: Communications Network

  3. E2 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (SYNC MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the APIM self-test.

    Are any Diagnostic Trouble Codes present? 

    Yes  For DTC C1001:01, GO to Pinpoint Test A  For all other Diagnostic Trouble Codes (DTCs), see the APIMDTC Chart. REFER to: Information and Entertainment System
    No  GO to  E3

  4. E3 CHECK FOR CORRECT REAR PARKING AID CAMERA OPERATION

    • Ignition OFF.

    • Disconnect and inspect the rear parking aid camera connector.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the rear parking aid camera connector. Make sure it seats and latches correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera 
    No  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals