Pinpoint Test E: The Manual Zoom Is Inoperative - Vehicles With Rear Only Parking Aid Camera
- Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
Possible Sources
- Communication network concern
- Rear parking aid camera
- LIN concern
- APIM concern
Visual Inspection and Pre-checks
- If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Verify the rear video camera configuration using the diagnostic scan tool.
- E1 PERFORM A NETWORK TEST
- Ignition ON.
- Using a diagnostic scan tool, perform a network test.
Do all modules pass the network test?
Yes GO to E2 No REFER to: Ethernet Module Communications Network - E2 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) present?
Yes REFER to the Diagnostic Trouble Code (DTC) Chart . No GO to E3 - E3 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (SYNC MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the APIM self-test.
Are any Diagnostic Trouble Codes present?
Yes For DTC C1001:01, GO to Pinpoint Test A For all other Diagnostic Trouble Codes (DTCs), REFER to: Information and Entertainment System No GO to E4 - E4 CHECK FOR CORRECT REAR PARKING AID CAMERA OPERATION
- Ignition OFF.
- Disconnect and inspect the rear parking aid camera connectors.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the rear parking aid camera connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera No The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.