Rear Parking Aid Camera: Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the reversing lamps. Refer to: Reversing Lamp
Disconnect the electrical connector and separate the rear view camera washer tube connector.

Courtesy of FORD MOTOR COMPANY
Push the wiring harness grommet through the liftgate outer panel.

Courtesy of FORD MOTOR COMPANY
Remove the nuts in the sequence shown.
Torque : 28 lb.in (3.2 Nm)

Fig 1: Lift Gate Panel Loosening Sequence
Courtesy of FORD MOTOR COMPANY
Remove the liftgate panel applique.

Courtesy of FORD MOTOR COMPANY
Remove the screws and the rear view parking aid camera bracket.

Courtesy of FORD MOTOR COMPANY
Disconnect the rear view camera washer hose and the electrical connector.

Courtesy of FORD MOTOR COMPANY
Remove the camera and washer nozzle assembly, remove the washer nozzle and remove the rear parking aid camera.

Courtesy of FORD MOTOR COMPANY