LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Edge ST-Line, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test G: The Odometer Is Inoperative >> Pinpoint Test G: The Odometer Is Inoperative

Pinpoint Test G: The Odometer Is Inoperative

  1. G1 CHECK FOR CORRUPTED NON-VOLATILE MEMORY (NVM)

    • Ignition ON.

    • Observe the message center display area.

    Does the odometer display ERROR? 

    Yes  INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) 
     
    No  GO to  G2

  2. G2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart: DTC Chart: Instrument Panel Cluster (IPC) .
    No  GO to  G3

  3. G3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Controller Area Network (CAN) Module Communications Network
     
    No  DIAGNOSE all PCM Diagnostic Trouble Codes (DTCs). Refer to the appropriate Engine System article for the procedure.
scientia non olet · About LEMON Manuals