LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> EcoSport SES >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Aw : The Headlamps On Warning Chime Is Inoperative

Pinpoint Test Aw : The Headlamps On Warning Chime Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Headlamps On Warning Chime. REFER to: Warning Chimes - System Operation and Component Description .

    Possible Sources 

    • GWM concern
    • BCM
    • IPC

  2. AW1 CHECK THE SEATBELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver seatbelt.

    • Monitor the seatbelt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the seatbelt warning chime operate for approximately 6 seconds? 

    Yes  GO to  AW2
    No  GO to Pinpoint Test BC 
  3. AW2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart: Instrument Panel Cluster (IPC) 
    No  GO to  AW3
  4. AW3 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Body Control Module (BCM) .
    No  GO to  AW4
  5. AW4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CM DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes 
    No  INSTALL a new BCM. REFER to: Body Control Module (BCM) .