Block Heater: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
- Remove the LH fender splash shield. Refer to: Fender Splash Shield .
-
NOTE: Make sure the block heater wiring is routed and secured away from rotating or hot components.
Disconnect the block heater electrical connector.
- Remove the block heater.
Torque: 41 lb.ft (55 Nm)
- Inspect the O-ring seal and replace if necessary.