LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Bronco Wildtrak, 4D Utility >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine - 2.3L ECOBOOST (199KW/270PS)) >> Removal And Installation >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil pan. Refer to: Oil Pan .
  2. Mark the balancer unit and shafts on the top for reference that the balancer unit is at TDC.
    GFD623944Courtesy of FORD MOTOR COMPANY
  3. Remove the bolts and the oil screen and pickup tube.
    GFD624206Courtesy of FORD MOTOR COMPANY
  4. Remove and discard the oil screen and pickup tube O-ring seal.
    GFD624207Courtesy of FORD MOTOR COMPANY
  5. Remove the bolts and the oil outlet tube.
    GFD623945Courtesy of FORD MOTOR COMPANY
  6. Inspect the oil outlet tube O-ring seal and replace if damaged.
    GFD623946Courtesy of FORD MOTOR COMPANY
    1. Remove the oil inlet tube-to-bracket bolt.
    2. Remove the bolt and the oil inlet tube bracket.
    3. Remove the bolts and the oil inlet tube.
    GFD623947Courtesy of FORD MOTOR COMPANY
  8. Inspect the oil inlet tube O-ring seal and replace if damaged.
    GFD623948Courtesy of FORD MOTOR COMPANY
  9. NOTE: Due to the precision interior construction of the balancer unit, it should not be disassembled.

    Remove the bolts and the balance unit.

    GFD624208Courtesy of FORD MOTOR COMPANY
  10. Remove the adjustment shims from the seat faces of the balancer unit.
GFD623950Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals