Removal And Installation: Flexplate: Installation
WARNING: This page is about a different variant/trim than selected.
-
-
NOTE: Special bolts are used for installation. Do not use standard bolts.
Install the flexplate and the new bolts finger-tight.
- Install Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
- Tighten the bolts in sequence shown.
Torque: Stage 1: 37 lb.ft (50 Nm) Stage 2: 59 lb.ft (80 Nm) Stage 3: 83 lb.ft (112 Nm)
-
- Install the automatic transmission. Refer to: Transmission - 2.3L EcoBoost (199kW/270PS) .
- Use the Powertrain Control Module (PCM) Misfire Monitor Profile Correction routine in the diagnostic scan tool.
- Road test the vehicle.