Pinpoint Test Ab: Rattle At Shut Down
WARNING: This page is about a different variant/trim than selected.
- Normal Operation and Fault Conditions
- Broken dual mass flywheel
- With the engine running and the transmission in NEUTRAL, turn the ignition to the OFF position. If a harsh metallic noise is heard during the last revolutions just before the engine stops, remove the clutch and inspect the flywheel. REFER to: Clutch Disc and Pressure Plate
Possible Sources
- Dual mass flywheel
- Broken dual mass flywheel
Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods