Ignition Coil-On-Plug: Removal
WARNING: This page is about a different variant/trim than selected.
- Detach the wiring harness retainers.
- Release the retainer tabs and remove the upper cover.
- Remove the lower cover by pulling it upward.
-
- Detach the wiring harness retainer.
-
NOTE: If equipped with a sliding cover over the locking tab, slide the cover back to gain access to the tab.
Press the locking tab on the ignition coil-on-plug electrical connector and disconnect the electrical connector from the ignition coil-on-plug.
- Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs.
-
NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
Remove the retainers and the ignition coil-on-plugs.