LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Bronco Sport First Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 810 (Engine Cooling - 2.5L DURATEC - Hybrid (121KW/164PS) (BG)) >> Removal And Installation >> Heater Hoses >> Removal

Heater Hoses: Removal

WARNING: This page is about a different car, the 2021 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding 
  2. Remove the cowl panel grille. Refer to: Cowl Panel Grille
  3. Release the clamp and disconnect the coolant hose. Use the General Equipment: Hose Clamp Remover/Installer
    GFD588177Courtesy of FORD MOTOR COMPANY
  4. Release the clamp and disconnect the coolant hose. Use the General Equipment: Hose Clamp Remover/Installer
    GFD588178Courtesy of FORD MOTOR COMPANY
  5. Release the clamps and remove the heater hoses. Use the General Equipment: Hose Clamp Remover/Installer
GFD588179Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals