Turbocharger Oil Supply Tube: Installation

NOTE: Do not reuse the turbocharger oil filter, a new turbocharger oil filter must be used.

NOTE: Ensure that new turbocharger oil supply tube O-rings and gaskets are used.

Install the new turbocharger oil supply tube O-rings, gaskets and oil filter if not already installed. Lubricate the O-ring seals with clean engine oil. Refer to Specifications .

Courtesy of FORD MOTOR COMPANY
NOTE: The oil supply tube must be fully seated prior to fastener tightening.
1. NOTE: Do not use a metal brush, damage to sealing area will result in leaks.
  
  Carefully use a nylon brush to remove the old O-ring residue, use brake cleaner to rinse the O-ring residue out of the turbocharger and engine O-ring bores. Inspect the area for deep scratches and gouges. Install new components if needed.
  
  Material
  
  : Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
2. Install and fully seat the turbocharger oil supply tube, then install and tighten the bolts.
  Torque
  
  : 97 lb.in (11 Nm)
Courtesy of FORD MOTOR COMPANY
Install the upper charge air cooler inlet pipe, then tighten the clamp. Engage the inlet pipe lower retaining clip. Attach the harness retainer to the inlet pipe, then connect the turbocharger bypass valve electrical connector.
Torque

: 44 lb.in (5 Nm)

Courtesy of FORD MOTOR COMPANY
Install the air cleaner outlet pipe. Refer to Air Cleaner Outlet Pipe .
Check the engine oil level and fill as needed. Refer to Specifications .