Spark Plug Wire: Removal

WARNING: This page is about a different car, the 2021 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Disconnect the battery. Refer to: Battery Disconnect and Connect
If equipped: Detach the wiring harness retainer. Remove and discard the nuts and remove the strut tower cross brace.
Torque: 41 lb.ft (55 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the engine appearance cover caps.

Courtesy of FORD MOTOR COMPANY
NOTE: The engine appearance cover rubber grommets may remain on the cover. If so, remove the grommets from the cover and install them on the intake manifold before installing the cover.

Remove the nuts and the engine appearance cover.

Torque: 35 lb.in (4 Nm)

Courtesy of FORD MOTOR COMPANY
Use compressed air to remove any foreign material in the spark plug well before removing the spark plug wire.
Disconnect and remove the spark plug wire.

Courtesy of FORD MOTOR COMPANY