Ignition Coil-On-Plug: Removal
WARNING: This page is about a different car, the 2021 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- If equipped. Detach the wiring harness retainer. Remove and discard the nuts and remove the strut tower cross brace.
- Remove the engine appearance cover caps.
-
NOTE: The engine appearance cover rubber grommets may remain on the cover. If so, remove the grommets from the cover and install them on the intake manifold before installing the cover.
Remove the nuts and the engine appearance cover.
- Remove the high-pressure fuel pump bracket bolt, discard it, remove the bracket.
Torque: 22 lb.ft (30 Nm)
-
NOTE: When removing or installing the fuel injection pump noise insulator, spreading the openings will reduce the risk of damage.
- Disconnect the electrical connector.
- Remove the fuel injection pump noise insulator.
- Disconnect the ignition coil-on-plug electrical connectors.
- Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs.
-
NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
- Remove the ignition coil-on-plug retaining bolts.
- Remove the ignition coil-on-plugs.