Exhaust Manifold LH: Installation

WARNING: This page is about a different car, the 2021 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.
Clean all exhaust connections before reassembly.
1. Position the exhaust manifold onto the engine and finger-tight the nuts.
2. Tighten the nuts in the sequence shown.
  Torque: Stage 1: 18 lb.ft (24 Nm) Stage 2: 24 lb.ft (32 Nm)
Fig 1: Exhaust Manifold (LH) Bolts Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Check the exhaust system for leaks.