Crankshaft Front Seal: Installation
WARNING: This page is about a different car, the 2021 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the engine front cover bore and the crankshaft front oil seal inner lip with clean engine oil.
-
NOTE: Only the plate from 303-335 should be used.
Using the special tools, install the new crankshaft front oil seal. Use Special Service Tool: 303-1531 Installer, Front Crank Seal and Damper., 303-335 (T88T-6701-A) Installer, Front Cover Oil Seal.
- Install the crankshaft pulley. Refer to: Crankshaft Pulley
- Use the Powertrain Control Module (PCM) Misfire Monitor Profile Correction routine in the diagnostic scan tool.
- Road test the vehicle