Turbocharger Oil Supply Tube: Installation

NOTE: A new turbocharger oil supply tube filter must be installed. Failure to install a new filter will cause turbocharger failure.

Install the new O-rings if not already installed. Lubricate the O-ring seals with clean engine oil. Refer to Specifications .

Courtesy of FORD MOTOR COMPANY
NOTE: The oil supply tube must be fully seated prior to fastener tightening.
- NOTE: Do not use a metal brush, damage to sealing area will result in leaks.
  
  Carefully use a nylon brush to remove the old O-ring residue, use brake cleaner to rinse the O-ring residue out of the turbocharger and engine O-ring bores. Inspect the area for deep scratches and gouges. Install new components if needed.
  
  Material
  
  : Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
1. Install and fully seat the new turbocharger oil supply tube, then install and finger tighten the bolts at this stage.
  Torque
  
  : Tighten 1 to: 89 lb.in (10 Nm)
  
  Tighten 2 to: 89 lb.in (10 Nm)
  
  Tighten 3 to: 22 lb.ft (30 Nm)
Courtesy of FORD MOTOR COMPANY
Install the air cleaner outlet pipe. Refer to Air Cleaner Outlet Pipe .
Check and top off the engine oil as needed. Refer to Specifications .