Pinpoint Test D: The Speedometer Is Inoperative
- Normal Operation and Fault Conditions
See Speedometer. Refer to Instrument Panel Cluster (IPC) - System Operation and Component Description .
If the vehicle speed message is missing or invalid for 5 seconds or longer, the IPC defaults the speedometer to 0 km/h (0 mph).
Possible Sources
- Communication concern
- GWM
- PCM
- IPC
- D1 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the IPC self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs) from the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes Refer to Diagnostic Trouble Code (DTC) Chart No GO to D2 - D2 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes Refer to Communications Network . No GO to D3 - D3 PERFORM THE SPEEDOMETER ACTIVE COMMAND USING A DIAGNOSTIC SCAN TOOL
- Using a diagnostic scan tool, view the IPC Parameter Identifications (PIDs).
- Access the IPC and control the SPDOMETER (%) PID
- Command the speedometer on and off while monitoring the speedometer.
Does the speed begin at 0 km/h (0 mph) move to 257 km/h (160 mph) and return to 0 km/h (0 mph)?
Yes DIAGNOSE all PCM Diagnostic Trouble Codes (DTCs). Refer to the appropriate DTC Index. No INSTALL a new IPC. Refer to Instrument Panel Cluster (IPC) .