LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Bronco Sport Base >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BT: The Parking Brake Warning Chime Is Inoperative

Pinpoint Test BT: The Parking Brake Warning Chime Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Parking Brake Warning Chime. Refer to Warning Chimes - System Operation and Component Description .

    Possible Sources 

    • Brake warning indication concern
    • Communication concern
    • BCM
    • GWM
    • IPC

  2. BT1 CHECK THE SEATBELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver seatbelt.

    • Monitor the seatbelt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the seatbelt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BT2
    No  GO to Pinpoint Test BV 

  3. BT2 CHECK THE BRAKE WARNING INDICATOR FOR CORRECT OPERATION

    • Apply the parking brake.

    • Observe the brake warning indicator.

    Does the brake warning indicator illuminate? 

    Yes  GO to  BT3
    No  GO to Pinpoint Test Q 

  4. BT3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  Refer to Diagnostic Trouble Code (DTC) Chart 
    No  GO to  BT4

  5. BT4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  Refer to Communications Network .
    No  DIAGNOSE all BCM Diagnostic Trouble Codes (DTCs). Refer to the appropriate DTC Index.
scientia non olet · About LEMON Manuals