Turbocharger Coolant Supply Tube LH: Installation
- If needed, then install the turbocharger cooling tube rubber gasket, then lubricate with clean engine coolant. Refer to: Specifications .
- Install a new O-ring seal, then lubricate with clean engine coolant. Refer to: Specifications
.
-
-
NOTE: Do not use a metal brush, damage to sealing area will result in leaks.
Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore. Inspect the area for deep scratches and gouges. Install new components as needed.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
- Install the turbocharger coolant supply tube to the turbocharger, then install and tighten the bolt.
Torque: 89 lb.in (10 Nm)
-
- Install the turbocharger LH. Refer to: Turbocharger LH .