Pinpoint Test BB: The Off Road Display Is Inoperative
- Normal Operation and Fault Conditions
See Off Road Display. REFER to: Message Center - System Operation and Component Description .
If the 4x4 high/low status, 4x4 wheel request status, vehicle pitch angle display, vehicle roll angle display and steering wheel angle messages are missing for less than 5 seconds, the IPC defaults the associated display element to the last display based on the last data received.
If the 4x4 high/low status, 4x4 wheel request status, vehicle pitch angle display, vehicle roll angle display and steering wheel angle messages are missing for 5 seconds or longer, the IPC sets a lost communication DTC for the module in question and defaults the associated display element off or blank.
Possible Sources
- Communication concern
- ABS module concern
- GWM concern
- PSCM concern
- AWD module concern
- IPC
- BB1 VERIFY THE IPC (INSTRUMENT PANEL CLUSTER) IS SET TO THE OFF ROAD DISPLAY
- Ignition ON.
-
NOTE: The IPC and message center navigation can be found in the Owner's Literature.
Using the message center controls, make sure the IPC is set to the off road display.
Is the IPC set to the off road display?
Yes GO to BB2 No The off road display is operating correctly. The IPC was not set to the correct display. - BB2 PERFORM THE AWD (ALL-WHEEL DRIVE) MODULE SELF-TEST
- Using a diagnostic scan tool, perform the AWD module self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes For 4x4 with part time engagement, REFER to: Four-Wheel Drive Systems . . For advanced 4x4 with 4A mode, REFER to: Four-Wheel Drive Systems . No GO to BB3 - BB3 PERFORM THE ABS (ANTI-LOCK BRAKE SYSTEM) MODULE SELF-TEST
- Using a diagnostic scan tool, perform the ABS module self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Anti-Lock Brake System (ABS) and Stability Control . No GO to BB4 - BB4 PERFORM THE PSCM (POWER STEERING CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the PSCM self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Power Steering . No GO to BB5 - BB5 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CM DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Controller Area Network (CAN) Module Communications Network . No GO to BB6 - BB6 CHECK FOR CORRECT IPC (INSTRUMENT PANEL CLUSTER) OPERATION
- Ignition OFF.
- Disconnect and inspect the IPC connector.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the IPC connector. Make sure it seats and latches correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.