Fuel System
WARNING: This page is about a different car, the 2019 Ford SSV Plug-in Hybrid, 2019 Ford Police Responder Hybrid, and 2019 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
The fuel tank and lines consist of the:
- single container (L-shaped) fuel tank.
- lifetime in tank fuel filter (serviced as part of the fuel pump).
- Easy Fuel™ (capless) fuel tank filler pipe assembly, which cannot be modified in any way and is serviced only by the installation of a new fuel tank filler pipe assembly.
- fuel level sensor.
- has fuel tubes (liquid and vapor).
- FPDM
- fuel tank pressure sensor (part of the fuel vapor tube assembly).
- fuel pump and sender.
The vehicle:
- has a serviceable fuel level sender mounted on the fuel pump.
- has a fuel tank filler pipe which contains a restrictor plate to permit only unleaded fuel to be pumped into the fuel tank.
- has an Easy Fuel™ (capless) fuel tank filler pipe assembly, which cannot be modified in any way.
- has a supplemental refueling adapter located in the luggage compartment, or behind the rear seat.
- has a lifetime in tank fuel filter serviced as part of the fuel pump.
- has fuel tubes (liquid and vapor) combined in a bundle along with the brake tubes mounted on the underside of the floorpan and covered with a protective cover shield.
- has quick connect and spring lock fuel tube couplings.
- has a FPDM that shuts off fuel in the event of a collision.
Fuel Pump Shut-off Feature
NOTE:
Refer to the PERIMETER ANTI-THEFT ALARM - SYSTEM OPERATION AND COMPONENT DESCRIPTION
to review the procedures for achieving the various ignition states (ignition OFF, ignition in ACCESSORY, ignition ON and ignition START) on vehicles with this feature.
The event notification feature provides other vehicle subsystems with information pertaining to SRS deployment or fuel cutoff status. When an impact occurs which exceeds a pre-determined threshold, the RCM sends a signal on a dedicated circuit to the BCM.
When the BCM receives a crash signal input from the RCM, the BCM initiates fuel cutoff by removing the ground signal from the Fuel Pump Relay and also sends a signal to the PCM on a dedicated circuit, disabling the fuel system.
After the fuel system is disabled, the vehicle can be re-started after carrying out the following steps:
- Turn the ignition OFF.
- Turn the ignition to START (on vehicles with push button start, press the start/stop button while the brake pedal is pressed).
- Turn the ignition OFF.
- Turn the ignition ON.