LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium, FWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Rear Seats (Except Hybrid) >> Removal And Installation >> Rear Seat Backrest Latch >> Removal

Rear Seat Backrest Latch: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the rear seat cushion. Refer to: Rear Seat Cushion .
    1. Remove the bolt and position the rear center safety belt aside. Lift the rear seat latch release handle.

      Torque

      : 35 lb.ft (48 Nm)

    2. Lower the rear seat backrest.
    3. Rotate the backrest hinge locking arm to release the backrest.
    4. Remove the seat backrest.
    GFD485101Courtesy of FORD MOTOR COMPANY
    NOTE: It is necessary to remove the 40 percent seat backrest before the 60 percent seat backrest will release.
    1. Lift the rear seat latch release handle.

      Torque

      : 35 lb.ft (48 Nm)

    2. Lower the rear seat backrest. Remove the backrest latch bezel. Unzip the backrest cover and release the backrest cover J-clips.
    3. Rotate the backrest hinge locking arm to release the backrest.
    4. Remove the seat backrest.
    GFD485102Courtesy of FORD MOTOR COMPANY
    1. Remove the screw.

      Torque

      : 44 lb.in (5 Nm)

    2. Remove the seat latch bezel.
    3. Position aside the backrest cover foam.
    GFD485103Courtesy of FORD MOTOR COMPANY
  2. Remove the bolts and the rear seat backrest latch.

    Torque

    : 18 lb.ft (24 Nm)

GFD485104Courtesy of FORD MOTOR COMPANY