LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Front Seats (2 Of 2) (Except Hybrid) >> Removal And Installation >> Front Seat Track >> Removal

Front Seat Track: Removal

NOTE: Note the wire harness routing for installation purposes.
  1. Remove the front seat backrest. Refer to: Front Seat Backrest  .
  2. Remove the front seat cushion cover. Refer to: Front Seat Cushion Cover  .
  3. NOTE: Passenger seat only.

    Detach the front pin-type retainers, lift the bladder and feed the OCS hose and sensor out from between the front seat cushion support wires.

    GFD485052Courtesy of FORD MOTOR COMPANY
  4. NOTE: Passenger seat only.

    • Disconnect the OCS sensor electrical connector, release the tab and remove the OCS sensor.

    • Route the OCS sensor and hose through the front seat cushion suspension wires.

GFD485053Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals