Pinpoint Test Z : The Visual Park Aid Alert Is Inoperative
- Z1 VERIFY THE VISUAL PART AID ALERT IS ENABLED
- Ignition ON.
- In the rear camera settings, verify the visual park aid alert is enabled. Refer to the Owners Manual.
Is the visual park aid alert enabled?
Yes GO to Z2 No ENABLE the visual park aid alert. - Z2 CHECK THE DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE PAM (PARKING ASSIST CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the PAM self-test.
Are any PAM Diagnostic Trouble Codes (DTCs) recorded?
Yes REPAIR all PAM Diagnostic Trouble Codes (DTCs) first. REFER to the DTC Chart: Parking Aid Module (PAM) . No GO to Z3 - Z3 CHECK THE DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
BCM Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: BCM . No GO to Z4 - Z4 CHECK FOR CORRECT VIDEO CAMERA OPERATION
- Ignition OFF.
- Disconnect and inspect the rear video camera and all related in-line connectors.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the rear video camera and all related in-line connectors. Make sure it seats and latches correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a Technical Service Bulletin (TSB) exists for this concern, DISCONTINUE this test and FOLLOW Technical Service Bulletin (TSB) instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new video camera. REFER to: Parking Aid Camera - 4-Door . No The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.