LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Handles, Locks, Latches And Entry Systems (Except Hybrid) >> Removal And Installation >> Luggage Compartment Lid Latch >> Removal

Luggage Compartment Lid Latch: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Open the luggage compartment lid.
    GFD484832Courtesy of FORD MOTOR COMPANY
    1. Position aside the luggage compartment lid pull handle cover.
    2. Remove the trim cover.
    3. Remove the screws and the luggage compartment pull handle.
    GFD484833Courtesy of FORD MOTOR COMPANY
  3. Insert a flat blade screwdriver in the housing slot and slowly pry down to disengage tabs on the latch. Pull down on the latch trim cover and remove. Use the General Equipment: Flat-Bladed Screwdriver
    GFD484834Courtesy of FORD MOTOR COMPANY
    1. Remove the pin-type retainers.
    2. Remove the trim panel, passing the emergency release handle through the trim panel opening.
    GFD484835Courtesy of FORD MOTOR COMPANY
  5. Remove the luggage compartment lid latch.

    • Disconnect the luggage compartment lid latch electrical connector.

    • Remove the nuts.

      Torque: 80 lb.in (9 Nm)

    • Remove the luggage compartment lid latch.

GFD485249Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals