LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 527 (Evaporative Emissions - 2.0L DURATEC - Hybrid (103KW/140PS) (UA)) >> Removal And Installation >> Fuel Tank Isolation Valve >> Removal

Fuel Tank Isolation Valve: Removal

WARNING: This page is about a different car, the 2019 Ford SSV Plug-in Hybrid, 2019 Ford Police Responder Hybrid, and 2019 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. Disconnect the negative battery cable. Refer to: Battery Disconnect and Connect .
  3. Remove the EVAP canister. Refer to: Evaporative Emission Canister - Plug-In Hybrid Electric Vehicle (PHEV) . Refer to: Evaporative Emission Canister - Plug-In Hybrid Electric Vehicle (PHEV) .
    1. Disconnect the the quick release couplings. Refer to: Quick Release Coupling .
    2. Disconnect the electrical connector.
    3. Remove the fuel tank isolation valve.
GFD435935Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals