LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Vehicle Dynamic Suspension (Except Hybrid)) >> Removal And Installation >> Vehicle Dynamics Control Module (VDM) >> Installation

Vehicle Dynamics Control Module (VDM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
  2. Using a diagnostic scan tool, complete the PMI process for the VDM following the on-screen instructions.
  3. Calibrate the VDM. Connect the diagnostic scan tool and carry out the Ride Height Calibration routine. Follow the on-screen instructions.
scientia non olet · About LEMON Manuals