LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Vehicle Dynamic Suspension (Except Hybrid)) >> Removal And Installation >> Rear Suspension Height Sensor >> Installation

Rear Suspension Height Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: The RH and LH height sensor assemblies cannot  be used on opposite sides of the vehicle.

    To install, reverse the removal procedure.

  2. Calibrate the suspension height sensor. Connect the scan tool and carry out the Ride Height Calibration routine. Follow the scan tool directions.
scientia non olet · About LEMON Manuals