LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 74 (Engine Controls - Powertrain DTC Descriptions (Except Diesel & Hybrid) - DTC P023A - P060D) >> DTC P0303 - Cylinder 3 Misfire Detected

DTC P0303 - Cylinder 3 Misfire Detected

WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION P0303 - CYLINDER 3 MISFIRE DETECTED

Description:  This DTC sets when the misfire detection monitor detects an engine misfire in cylinder 3.
Possible Causes: 
  • Ignition system
  • Fuel injector 3
  • Running out of fuel
  • EVAP purge valve
  • Fuel pressure
  • Evaporative emission system
  • Exhaust gas recirculation (EGR) system
  • Base engine
  • Misfire monitor neutral profile correction has not been relearned since the last mechanical repair
Diagnostic Aids:  Misfire is defined as lack of combustion in a cylinder due to absence of spark, incorrect fuel metering, low compression, or any other cause.
The malfunction indicator lamp (MIL) blinks once per second when a misfire severe enough to cause catalyst damage is detected. If the MIL is on steady state due to a misfire, this indicates the threshold for emissions was exceeded and caused the vehicle to fail an inspection and maintenance tailpipe test.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST HD .
scientia non olet · About LEMON Manuals