DTC P0125 - Insufficient Coolant Temp For Closed Loop Fuel Control

WARNING: This page is about a different variant/trim than selected.

DTC DESCRIPTION P0125 - INSUFFICIENT COOLANT TEMP FOR CLOSED LOOP FUEL CONTROL

Description:	This DTC sets when the engine coolant temperature (ECT) or the cylinder head temperature (CHT) sensor has not achieved the required temperature level to enter closed loop operating conditions within a specified amount of time after starting the engine.
Possible Causes:	Insufficient warm up time Low engine coolant level Leaking or stuck open thermostat Damaged ECT sensor Damaged CHT sensor
Diagnostic Aids:	Compare the thermostat specification to the actual engine coolant temperature using the engine temperature PID (ECT or CHT). The temperature reading should be similar when the engine is at a normal operating temperature.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
Continental 2.0L,	GO to PINPOINT TEST DX .
Continental 2.7L,
Continental 3.0L,
Corsair,
EcoSport 1.0L,
EcoSport 1.5L,
EcoSport 2.0L,
Edge,
Escape/Kuga,
Explorer,
Fusion 1.5L,
Fusion 2.0L,
Fusion 2.7L,
KA,
MKZ,
Mustang 2.3L,
Nautilus,
Ranger,
Transit Connect
All others	GO to PINPOINT TEST DL .