DTC P0015 - B Camshaft Position Timing - Over-Retarded (Bank 1)

WARNING: This page is about a different variant/trim than selected.

DTC DESCRIPTION P0015 - B CAMSHAFT POSITION TIMING AND OVER-RETARDED (BANK 1)

Description:	This DTC sets when the variable camshaft timing (VCT) position is over-retarded. This DTC sets when the camshaft timing exceeds a maximum calibrated value or remains in a retarded position.
Possible Causes:	VCT unit to camshaft alignment Camshaft timing incorrectly set Continuous oil flow to the VCT piston chamber Erratic camshaft position due to low oil pressure Oil flow restriction in the oil passages or the VCT valve body Variable camshaft timing bank 1 solenoid 2 (VCT12) valve stuck open VCT12 circuit open VCT12 circuit short to voltage VCT12 circuit short to ground VPWR circuit open Camshaft advance mechanism binding (VCT unit) Damaged VCT12 phaser Damaged camshaft position bank 1 sensor 2 (CMP12) CMP12 sensor circuits open CMP12 sensor circuits short to voltage CMP12 sensor circuits short to ground Radio frequency interference
Diagnostic Aids:	This DTC may be accompanied by other DTCs. Diagnose all camshaft position (CMP) sensor DTCs first. If no CMP sensor related DTCs are present, continue to follow diagnosis for this DTC. This DTC is a functional check of the VCT unit. Diagnose any base engine concerns related to the engine oil pressure or engine timing. Refer to the Engine System General Information article, Oil Pressure Test, to check the engine oil pressure. Refer to the Engine article to check the engine timing and VCT phasers.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST HK .