LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 71 (Engine Controls - Pinpoint Test KF: Fan Control Relays Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid)) >> Pinpoint Test Kn: Variable Speed Electric Cooling Fan Motor >> Introduction

Pinpoint Test Kn: Variable Speed Electric Cooling Fan Motor: Introduction

WARNING: This page is about a different variant/trim than selected.

This pinpoint test is intended to diagnose the following:

Fig 1: Cooling Fan (CF) Module Connector
G13533310Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
GND (Ground) 2
FCV (Fan Control Variable) 4
FANPWR (Fan Power) 1
Fig 2: Cooling Fan (CF) Motor Connector
G13533311Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
FANPWR (Fan Power) 2
GND (Ground) 1
Fig 3: Cooling Fan Motor 1 Connector
G13533312Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
Fig 4: Cooling Fan Motor 2 Connector
G13533313Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
Fig 5: Fan Control 1 (FC1) Relay Connector
G13533314Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
B+ (Battery Positive Voltage) 3
Fig 6: Fan Control 2 (FC2) Relay Connector
G13533315Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
Fig 7: Fan Control 3 (FC3) Relay Connector
G13533316Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
Fig 8: Powertrain Control Module (PCM) Connector - For PCM Connector Views
G13533317Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin