LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 68 (Engine Controls - Pinpoint Test A: No Start Through Pinpoint Test DN: Pressure And Temperature Sensors - (Except Diesel & Hybrid)) >> Pinpoint Test Di: Direct Fuel Injection Fuel Injector >> Introduction

Pinpoint Test Di: Direct Fuel Injection Fuel Injector: Introduction

WARNING: This page is about a different variant/trim than selected.
NOTE: Do not apply battery voltage across the fuel injector circuits. Permanent damage to the fuel injector may result.

This pinpoint test is intended to diagnose the following:

Fig 1: Direct Fuel Injection Fuel Injector Connector
G13533219Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
INJ (Injector) 1
INJRTN (Injector Return) 2
Fig 2: Powertrain Control Module (PCM) Connector - For PCM Connector Views
G13533220Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
INJ1 (Injector 1) E83
INJ1RTN (Injector 1 Return) E78
INJ2 (Injector 2) E82
INJ2RTN (Injector 2 Return) E77
INJ3 (Injector 3) E93
INJ3RTN (Injector 3 Return) E88
INJ4 (Injector 4) E94
INJ4RTN (Injector 4 Return) E89