LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 55 (Starting System - 2.5L DURATEC (125KW/170PS)) >> Diagnosis And Testing >> Starting System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify the customer concern by operating the starting system.
  2. Before diagnosing or repairing the starting system inspect the following items:

    • Check the battery for loose, damaged or corroded connections.
    • Check the generator for loose, damaged or corroded connections.
    • Check engine and battery grounds for loose, damaged or corroded connections.
    • Check high current BJB for loose or corroded connections.
    • Verify fuses or fusible links.
    • Inspect wiring, terminals and connectors.

  3. Check the battery condition and state of charge. REFER to: Battery .
  4. Check for abnormal ignition-off current drain(s). REFER to: Battery Drain Check .
  5. Remove the accessory drive belt. REFER to: Accessory Drive Belt . Verify the crankshaft and each of the components driven by the accessory drive belt rotate and are not seized or damaged.
  6. If any aftermarket accessories have been added to the vehicle, make sure they are properly wired.
  7. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding.
  8. Using the diagnostic scan tool, retrieve all Diagnostic Trouble Codes (DTCs). Refer to the appropriate DTC Charts  .
scientia non olet · About LEMON Manuals