Transmission Fluid Cooler - 2.0L EcoBoost (184kW/250PS) - MI4: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the active grille shutter. Refer to: Active Grille Shutter .
-
NOTE: The cooling module must be allowed to drop approximately 2 inches to allow clearance for transmission fluid cooler removal.
Support each side of the cooling module. Remove the radiator retaining pins.
- Remove the retainers and the lower radiator support.
-
NOTE: Be prepared to collect escaping fluid.
Release the clamps and disconnect the transmission cooler hoses.
- Remove the bolt and the transmission fluid cooler.