Receiver Drier Element - 2.7L EcoBoost (238kW/324PS): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
During the removal or installation of components, cap, tape or otherwise appropriately protect all openings and tubes/fittings to prevent the ingress of dirt or other contamination. Remove caps, tape and other protective materials prior to installation.
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the condenser. Refer to: Condenser - 2.7L EcoBoost (238kW/324PS) .
-
NOTE: Make sure that all openings are sealed.
Remove the receiver drier plug and the receiver drier element.
- Make sure to cover any open ports to prevent debris from entering the system.