External Controls - Overview

WARNING: This page is about a different variant/trim than selected.

Overview

The shift by wire system uses a rotary dial mounted on top of the GSM to command an actuator called the TRCM to change gear lever positions via a shift cable connected to the manual control lever located on the transmission.

The shift by wire system consists of:

a GSM that uses a rotary dial to select the desired gear.
a TRCM that changes the gear position via a shift cable.
a mechanical selector lever cable that connects the TRCM to the transmission.

Whenever the TRCM or selector lever cable is replaced the selector lever cable adjustment procedure must be performed.