LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Parking Brake And Actuation (Except Hybrid)) >> Removal And Installation >> Parking Brake Switch >> Installation

Parking Brake Switch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
  2. NOTE: Anytime the parking brake switch electrical connector has been disconnected, the EPB system is deactivated and a DTC is stored in the ABS module. Perform the following step to restore the EPB system and clear the ABS module DTC.

    Apply and release the parking brake twice within 5 seconds, pausing with the switch in the NEUTRAL position for approximately one-half second between each apply and release.

scientia non olet · About LEMON Manuals