LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Parking Brake And Actuation (Except Hybrid)) >> Diagnosis And Testing >> Parking Brake >> Pinpoint Tests >> Pinpoint Test E : The Parking Brake Does Not Hold The Vehicle, Does Not Apply, Does Not Release Using The Parking Brake Switch >> Notes

Pinpoint Test E : The Parking Brake Does Not Hold The Vehicle, Does Not Apply, Does Not Release Using The Parking Brake Switch: Notes

WARNING: This page is about a different variant/trim than selected.

Refer to Vehicle Dynamic System for schematic and connector information.

Normal Operation and Fault Conditions 

When the ABS module receives a parking brake apply or release request, the ABS module sends voltage to the parking brake actuator motors. The ABS module also monitors the current draw of the actuator motors to determine when the brake pads contact the brake disc, to determine when the appropriate amount of clamping force is being applied to the brake disc and to determine when the brake pads are retracted to their start position.

A HS-CAN issue or concern results in a failure to release the parking brake.

The ABS module runs self-tests before, during and after an apply or release request. These self-tests are done to determine parking brake system functionality. High actuator motor circuit resistance, a short to ground, a short to voltage, an open circuit, a mechanical or electrical failure of the actuator motor or an internal failure of the ABS module may cause one or more of these self-tests to fail resulting in the ABS module setting one or more Diagnostic Trouble Codes (DTCs).

The actuator motors have a serviceable jumper harness connecting the actuator motor to the body harness at C3050 for the LH actuator motor and C3134 for the RH actuator motor.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
C2005:1B, C2006:1B Right Actuator, Left Actuator: Circuit Resistance Above Threshold This DTC sets in continuous memory and on-demand if during an apply (clamping) command, the measured resistance in the motor circuit is higher than a predetermined threshold.
C2005:71, C2006:71 Right Actuator, Left Actuator: Actuator Stuck This DTC sets in continuous memory and on-demand if during an apply or release command, the ABS module detects no movement of the actuator motor.
C2007:13, C2008:13 Right Motor, Left Motor: Circuit Open This DTC sets in continuous memory and on-demand if the ABS module detects a difference in the current between the positive side and the negative side of the actuator motor.
C2007:1C, C2008:1C Right Motor, Left Motor: Circuit Voltage Out Of Range This DTC sets in continuous memory and on-demand if the ABS module detects a short to ground or a short to voltage on the actuator motor circuits.
C2007:92, C2008:92 Right Motor, Left Motor: Performance Or Incorrect Operation This DTC sets in continuous memory and on-demand if the ABS module detects a current greater than 23 amps after an apply or release request, detects a mismatch in motor control (power instead of ground or ground instead of power), or detects a power loss that exceeds a predetermined threshold during an apply or release function.
C2007:96, C2008:96 Right Motor, Left Motor: Component Internal Failure The ABS module tests the parking brake actuator motors by sending a voltage pulse through the circuits and the motors. This DTC sets when the test results are out of the expected range.

Possible Sources 

scientia non olet · About LEMON Manuals