Section 28 (Driveshaft (Except Hybrid)): Specifications
WARNING: This page is about a different variant/trim than selected.
| Driveshaft runout | 1.0 mm (0.040 in) |
|---|---|
| Driveshaft to PTU joint angle @ curb ride height | 5.259 degrees |
| Driveshaft center bearing "1" joint angle @ curb ride height (Center bearing closest to the PTU) | 4.572 degrees |
| Driveshaft center bearing "2" joint angle @ curb ride height (Center bearing closest to the RDU) | 1.635 degrees |
| Driveshaft to RDU joint angle @ curb ride height | 0.929 degrees |